Greenheck Fan PN 458294 manual End Filler Panel Installation Instructions, Hood Hanging Height

End Filler Panel Installation Instructions

End filler panels may be shipped loose for field installaton or are facory mounted to the hood. If fillers are factory mounted to hood, skip this section.

1.Uncrate the hood and lay it on the floor with protective material between the hood and the floor.

2.Bolt the filler panels together with 5/16 in. bolts from the hardware package.

3.Position the filler panels on the hood and tack-weld them to the appropriate side of the hood.

4.To allow for ease of cleaning, caulk the external seams with

NSF Approved silicone caulk (GE SCS1009, or its equivalent). The caulk is not provided.

Note: Hood may be furnished with
finished end fillers when mounting
against a partial wall.	End Filler Panels	Fig. 3

Hood Hanging Height

The hood hanging height is critical, hanging the hood at the incorrect height may significantly reduce the ability for the hood to function properly and may be in violation of codes. The hood hanging height is given on the UL label located on the inside of the hood on the end panel. The distance given is from the front lip of the hood (shown in Fig. 4) to the surface of the cooking equipment.

Continuous Capture Plenum Hoods

Use the installation procedure described on page 4 for single island hoods; install and level both hoods. After leveling, secure the hoods together. Fasten the hoods together using u-clips and bolts. (Fig. 6) Caulk this joint with NSF Approved silicone caulk (GE SCS1009 or its equivalent). The caulk is not provided.

UL Vertical Distance

Above Cooking Surface

Fig. 4

Fig. 5

	HOOD
CAULK
BOLT	ACORN NUT

Fig. 6 U-CLIP

Proximity Hood

®