Grindmaster Removal from Carton and Pallet, Installing Your Unit, Crathco 5311 & 5511 Manual

Removal from Carton and Pallet

1)Remove staples or cut cardboard box around the stapled area.

2)Pull the cardboard box up off machine.

3)Remove the Styrofoam packing and the plastic bag.

4)Remove both side panels with screwdriver.

5)Use a wratchet with a 3 inch extension and a 7/16 socket to remove the shipping bolts (connecting the machine to the pallet) located on both sides of the frame bottom plate.

6)Supporting all four sides, lift machine up and place in appropriate area.

CAUTION: If equipped with spinner do not lift unit by spinner shaft to avoid serious damage ! to spinner.

Installing Your Unit

CAUTION: Do not alter or deform the plug in any way! Altering or deforming plug may damage

!unit and will void warranty! Receptacle required NEMA 5-20R for model 5311 and NEMA 6-20R for model 5511.

1)Place freezer in a location that allows adequate space at each side and above for proper air circulation. Minimum clearance is: 6” (15 cm) on both sides 0” at back and open above the freezer. (See Figure B)

CAUTION: Failure to allow adequate ventilation will void the warranty and reduce freezer performance.

2)Place the freezer on the self-sealing rubber pad on a level counter that is stable and strong enough to safely support its weight (200lbs.) (90.7kg), or if equipped with legs instead of pad, install legs by screwing them into the four leg holes on the bottom of the unit.

(Leg Kit Part #W089.0220 (4) 4” Legs)

3)Place On-Off-Clean switch in OFF position.

4)Install header by removing two screws from the electrical box ocover. Carefully remove electrical box cover. Place the header (transparency) between the clear and opaque plates (plastic lens). Slip the electrical box cover back on to machine and reinsert the four screws. (See Figure C)

5)Install the standard one piece carb tube by placing it in the hole in the hopper. If your unit is equipped with a two piece smoothie/shake carb tube place the solid piece in the hole in the hopper with the hole facing front to back. Then place the carb tube sleeve over the solid piece, lining up one of the holes with the hole in the solid piece. (Select the larger hole for thickest products).

6)Connect the power cord to a properly grounded 115V/20 Amp or

208-230V/20 Amp circuit (depending on the voltage of the dispenser).

Figure B

Figure C

Crathco® 5311 & 5511 Manual Page 3