6.Remove the rear pressure roller (4 hex bolts and 4 flat washers) along with the brack- ets, compression springs, and spring plates shown in Figure 41.
Spring |
Plate |
Compression |
Spring |
Bracket |
Figure 41. Rear pressure roller components.
7.Remove the rear panel.
8.Loosen the hex bolts securing the motor bracket to the frame, raise the motor and remove the V-belt from the motor pulley (see Page 27 for help). The drum sander should now look similar to Figure 42.
9.Remove the sanding drum (4 lock nuts and 4 flat washers) and V-belt (Figure 43).
Figure 43. Location to remove sanding drum
components.
10.Remove the front roller end guard covers (4 Phillip head screws) and the rear roller end guard covers (4 Phillip head screws), and set the covers aside. The drum sander should now look similar to Figure 44.
Figure 44. Drum sander disassembled to Step 10.
Figure 42. Drum sander disassembled
to Step 8.
G0459 12" Drum Sander |
