Grizzly G0490 Squaring Stock, Squaring stock involves four steps performed in the following order

Before turning the jointer ON, make sure the outfeed table height is properly set (refer to Setting Outfeed Table Height on Page 43 for detailed instructions) to avoid workpiece kickback and to ensure good results. Kickback of the workpiece could cause serious personal injury!

Squaring Stock

Squaring stock involves four steps performed in the following order:

1.Surface Plane on the Jointer: I]ZXdcXVkZ [VXZ d[ i]Z ldg`e^ZXZ ^h hjg[VXZ eaVcZY [aVi l^i]i]Z_d^ciZghZZFigure 33#

Figure 33.Hjg[VXZeaVc^c\dci]Z_d^ciZg#

2.Surface Plane on a Thickness Planer:

I]Z deedh^iZ [VXZ d[ i]Z ldg`e^ZXZ ^h hjg" [VXZeaVcZY[aVil^i]Vi]^X`cZhheaVcZghZZ

Figure 34#

EgZk^djhan

Hjg[VXZ

EaVcZY;VXZ

Figure 34.Hjg[VXZeaVc^c\dcVi]^X`cZhh

eaVcZg#

3.Edge Joint on the Jointer: I]Z XdcXVkZ ZY\Zd[i]Zldg`e^ZXZ^h_d^ciZY[aVil^i]i]Z _d^ciZghZZFigure 35#

Figure 35.:Y\Z_d^ci^c\dci]Z_d^ciZg#

4.Rip Cut on a Table Saw: I]Z_d^ciZYZY\Z d[ i]Z ldg`e^ZXZ ^h eaVXZY V\V^chi i]Z iVWaZ hVl [ZcXZ VcY i]Z deedh^iZ ZY\Z ^h Xji d[[ hZZFigure 36#

	EgZk^djhan
	?d^ciZY:Y\Z
	
	
Figure 36.G^eXjii^c\dcViVWaZhVl#

Making adjustments to the jointer while the machine is ON greatly increases the risk to the operator from the rotating cutterhead. ALWAYS make sure the jointer is OFF and disconnected from power before performing adjustments, maintenance, or service on the machine!

"'+" BdYZa<%).%$<%).%MB[\#H^cXZ($%.