Grizzly G0508 owner manual Test Run, To test run the dust collector

Test Run

Wear safety glasses whenever starting or using machine. Failure to comply may result in serious personal injury.

Keep loose clothing rolled up and out of the way of machinery and keep hair pulled back.

Do NOT put hands or small objects near inlet openings during opera- tion. Objects sucked into the inlet will meet with the impeller blade. Failure to heed this warning could result in property damage or per- sonal injury.

Once assembly is complete, test run your machine to make sure it runs properly.

To test run the dust collector:

1.Make sure you have read and understand all of the safety instructions starting on Page 6 of this manual, and make sure the machine is set up properly.

2.Connect the dust collector to the proper power source (reference Circuit Requirements on Page 9).

3.Clear away from the machine all tools and objects used during the setup.

4.Turn the machine ON by pushing in the GREEN button on the power switch.

5.Listen and watch for abnormal noises or operation. The machine should run smoothly with little or no vibration or rubbing noises.

—Strange or unusual noises MUST be inves- tigated and corrected before operating the machine further. Always disconnect the machine from power before investigating or correcting potential problems.

—If you cannot easily locate the source of a potential problem, refer to Troubleshooting on Page 30 or contact our Technical Support at (570) 546-9663.

6.Turn OFF the machine by pushing in the RED button on the power switch.

-16- G0508 10 HP Industrial Dust Collector