5.Attach the supporting legs to the housing bracket with
6.Position the base on top of the supporting legs (see Figure 8).
Flange Bolts
Figure 8. Base attached to supporting leg.
7.Fasten the supporting legs to the base with 5⁄16"-18 x 1⁄2" flange bolts.
8.With assistance, turn the entire assembly over so that the casters rest on the floor.
9.Position and hold the rubber gasket against the square opening in the main housing (see Figure 9).
Main Housing |
Collector |
Mounting Bolts |
Rubber Gasket |
Figure 9. Collector mounted to main housing.
10.With assistance, position and hold the collec- tor so the holes in the collector flange match with those of the rubber gasket and main housing.
11.Insert and hand tighten one 5⁄16"-18 x 1" flange bolt, two 5⁄16" flat washers, and one 5⁄16"- 18 hex nut in all eight holes.
12.Tighten the eight flange bolts and nuts in a alternating fashion so that the rubber gasket is evenly compressed without deformation.
13.Repeat Steps 10–13 for the remaining col- lectors.
14.Place the inlet on the top center circular flange of the main housing (see Figure 10).
Screw
Figure 10. Inlet mounted on main housing.
15.Rotate the inlet so the hole in the inlet aligns with the hole in the housing flange.
16.Use the M6-1 x 10 Phillips head screw to fas- ten the inlet securely to the housing flange.
G0508 10 HP Industrial Dust Collector |
