Grizzly G0555 Installing Table, Positive Stop, To install the table on the bandsaw

	Installing	Installing Table
	Positive Stop
		To install the table on the bandsaw:
To install the positive stop:		1. Remove the aluminum table insert from the
1. Locate the M8-1.0 x 80 hex bolt (this is the		center of the table and remove the table pin
		from the end of the table slot.
positive stop bolt) from the hardware bag and
thread on the remaining M8-1.0 hex nut from		2. Line up the blade with the table slot and pass
the hardware bag.		the table around the blade until the blade is
2. Thread the positive stop bolt into the band-		in the center of the table, then turn the table
		90û counterclockwise and rest the table trun-
saw into the trunnion base so that it is		nions on the trunnion base. The trunnion
installed similar to Figure 15. The positive		bolts should be hanging out of the bottom of
stop depth will be set after the table has been		the trunnion base at this point.
installed.
		3. Locate the two knobs from the hardware bag
		and thread them onto the trunnion bolts that
		hang out through the bottom of the trunnion
		base as illustrated in Figure 16.
	Positive
	Stop
	Bolt

Figure 15. Shows positive stop bolt installed.

Figure 16. Secure table to trunnion with knobs

from hardware bag.

4. Place the table insert in the center of the table, so that it sits flush with the table top surface.

5. Insert the pin into the end of the table slot.

-16- G0555 14" Ultimate Bandsaw