¥Straight Cutting Ñ Use the largest width blade that you own. The Model G0555 will accept blades up to 3Ú4" wide. Narrow blades can cut tight curves (a small radius) but are not very good at cutting straight lines because they naturally wander (blade lead). However, larger blades are much better at cutting straight lines, but function poorly at cutting small curves because of their size.
Tooth Style
When selecting blades, another option to consid- er is the shape, gullet size, teeth set and teeth angle Ñ otherwise known as ÒTooth Style.Ó
Figure 36 shows the three main categories of tooth style:
RakerSkip Hook
Figure 36. Raker, Skip & Hook tooth styles.
¥RAKER Ñ This style is considered to be the standard because the tooth size and shape are the same as the tooth gullet. The teeth on Raker blades usually are very numerous, have no angle, and produce cuts by scraping the material; these characteristics result in very smooth cuts, but at the same time do not cut fast and generate more heat while cutting.
¥SKIP Ñ This style is similar to a raker blade that is missing every other tooth. Because of the design, skip toothed blades have a much larger gullet than raker blades, and there- fore, cut faster and generate more heat. However, these blades also leave a rougher cut than raker blades.
¥HOOK Ñ The teeth on this style have a pos- itive angle (downward) which makes them dig into the material, and the gullets are usu- ally rounded for easier waste removal. These blades are excellent for the tough demands of resawing and ripping thick mate- rial.
Tooth Pitch
Usually measured as T.P.I. (teeth per inch), tooth pitch determines the size of the teeth. More teeth per inch (fine pitch) will cut slower, but smoother; while fewer teeth per inch (coarse pitch) will cut rougher, but faster. As a general rule, choose blades that will have at least three teeth in the material at all times. Use fine pitched blades on harder woods and coarse pitched blades on soft- er woods.
Blade Care
A bandsaw blade is a delicate piece of steel that is subjected to tremendous strain. You can obtain longer use from a bandsaw blade if you give it fair treatment and always use the appropriate feed rate for your operation.
Be sure to select blades with the proper width, style, and pitch for each application. The wrong choice of blades will often produce unnecessary heat which will shorten the life of your blade.
A clean blade will perform much better than a dirty blade. Dirty or gummed up blades pass through the cutting material with much more resistance than clean blades. This extra resis- tance also causes unnecessary heat.
G0555 14" Ultimate Bandsaw |
