Assembly & Setup
The Model G0711 requires a source of com- pressed air that can consistently deliver 4 CFM at
Since the Model G0711 must be lubricated before each use, and at regular operating intervals, we recommend using a filter/lubricator/regulator with your compressed air line (see Figure 6) below.
Quick | Quick | Regulator | |
| |||
Connector | Connector |
| |
| Lubricator | ||
Your |
| Air Compressor | |
Tool |
| ||
Air Hose | |||
Filter | |||
Quick | Quick | ||
| |||
Coupler | Coupler |
| |
Figure 6. Air line setup with filter/lubricator/regu-
lator installed.
The Model G0711 can also be filled with fine sand to reduce vibration and noise during operation; however, this is optional.
Items Needed for Assembly | Qty | |
• | Hex Wrench 4mm | 1 |
• | Hex Wrench 5mm | 1 |
• Fine Sand 40 Lb. Bag (Optional) | 1 | |
To assemble and set up the Model G0711:
1.Insert the hammer assembly into the top of the
Set Screw
Figure 7. Hammer installed in C-frame.
2.Pull the hammer assembly spring loop to the side and insert the hammer into the coil spring, making sure the ring on the ham- mer shaft is over the bottom spring loop, as shown in Figure 7.
|
| Spring |
Ring |
| Loop |
Hammer
Figure 8. Hammer installed in spring.
3.Insert a die into the die housing, as shown in
Figure 9.
Die
Figure 9. Die inserted.
4.Raise the die housing up, and insert the pin as shown in Figure 10 to position the die near the hammer.
Pin
Figure 10. Pin inserted through bracket and
housing to position the die upward.
Model G0711 (Mfg. Since 7/10) |
