Dust Collection |
| Power Connection |
|
|
|
|
|
|
DO NOT operate the Model G0716 without an adequate dust collection system. This sand- er creates substantial amounts of wood dust while operating. Failure to use a dust collec- tion system can result in short and
Recommended CFM at Dust Port: 400 CFM
Do not confuse this CFM recommendation with the rating of the dust collector. To determine the CFM at the dust port, you must consider these variables: (1) CFM rating of the dust collector,
(2)hose type and length between the dust col- lector and the machine, (3) number of branches or wyes, and (4) amount of other open lines throughout the system. Explaining how to cal- culate these variables is beyond the scope of this manual. Consult an expert or purchase a good dust collection
To connect a dust collection hose:
1.Fit the 4" dust hose over the dust collection elbow, as shown in Figure 14, and secure in place with a hose clamp.
2.Tug the hose to make sure it does not come off. Note: A tight fit is necessary for proper performance.
Figure 14. Dust hose attached to dust port.
Before the machine can be connected to the power source, an electrical circuit and connec- tion device must be prepared per the POWER SUPPLY section in this manual, and all previ- ous setup instructions in this manual must be complete to ensure that the machine has been assembled and installed properly.
Always make sure the power switch on the machine is turned OFF (or the OFF button is pushed in) before connecting/disconnecting power.
Connecting Power
Insert the power cord plug into a matching power supply receptacle. The machine is now connected to the power source.
Disconnecting Power
If you need to disconnect the machine from power later, pull the plug completely out of the recep- tacle. Make sure to grasp the plug when pulling it from the
Model G0716 (Mfg. Since 2/11)
