SECTION 4: ASSEMBLY
OverviewHandwheel
The G1021Z Planer requires very little assembly when you receive it. There a just a few easy assembly steps to get the machine ready for your shop. The machine should be properly adjusted from the factory, however should you desire to check the various settings, the following section will detail the proper adjustment procedures.
This planer unit is very heavy, approximately 480 lbs. There are lifting handles which slide out of the base of the planer head (Figure 2) which can be used to move the unit. These can be used as lifting points using an overhead lift, block and tackle or a forklift, or if you have three other friends who are each willing to grab a handle!
Lifting Handles 
Figure 2. Location of lifting handles.
This planer is heavy and awkward to move. We recommend that you use the proper equipment to put the planer into position in your shop or on a mobile base. Lifting without proper equipment or ample assistance could result in serious injury.
The handwheel is used to raise and lower the planer table.
TO MOUNT THE HANDWHEEL:
1.The handwheel shaft is at the front right corner of the planer. Insert the key into the keyway on the shaft, then line up the notch on the handwheel bore with the key. Slide the handwheel onto the shaft.
2.Slide the direction scale over the keyed shaft so it sits on the center face of the handwheel. See Figure 3.
3.Secure the handwheel with the 10mm - 1.25 hex nut and washer provided.
4.Attach the handle to the outer edge of the handwheel. The handle threads into the hole on the handwheel.
Figure 3. Handwheel attachment.
G1021Z 15" Planer |