Dust Port
The G1021Z Planer features a 4" dust port for use with a dust collection system. If you will not be using a dust collection system with this plan- er, do not attach this dust port!
TO ATTACH THE DUST PORT:
1.Fit the dust port over the planer upper cover. Line up the mounting holes. Three holes go through the upper cover, and three holes on the flange line up with three threaded holes on the back of the planer head.
2.Use three (3) M6 - 1.0 x 12mm hex bolts and nuts and lock washers to secure the dust port to the planer upper cover. See Figure 7. It will be necessary to reach inside the port opening with a wrench to hold the nut to tighten the hex bolts.
3.Use three M6 - 1.0 x 12mm cap screws and flat washers to secure the dust port to the planer body.
Figure 7. Dust port assembly.
Knife Setting Jig
The knife setting jig has been provided to make knife setting quick and easy. See Figure 8.
TO ASSEMBLE THE KNIFE SETTING JIG:
1.Snap one of the
2.Slide the cast aluminum knife setting jig brackets onto the rod.
3.Snap the other
Jig Rod
Jig Bracket
Figure 8. Knife setting jig components.
Planer knives are dangerously sharp. Use extreme caution when working near cutting surfaces. Failure to exercise care while working near knives could result in severe personal injury.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
G1021Z 15" Planer | |||||