Handwheel
One handwheel has been removed for shipping. To install, place the handwheel over the threads and screw the lock knob into the center. Next insert the handle into the handwheel and tighten it as shown in Figure 14. Install the other handle onto the other handwheel.
Figure 14. Tightening handle onto handwheel.
Table Insert
The table insert provides support for the material being cut. It must be installed flush with the cast iron table surface.
To install the table insert:
1.Disconnect the machine from the power source!
2.Using the front handwheel, move the blade to its lowest position.
3.Set the table insert into the recessed area on the table surface.
4.Ensure that all four table insert setscrews (Figure 15) are firmly in contact with the table casting.
5.Using an allen wrench, raise or lower each of the four setscrews until the insert is flush with the table top.
6.Using the side handwheel, position the blade 90¡ to the table surface.
7.Wearing leather gloves, rotate the blade while raising and lowering it through its full range of motion. Make sure it never contacts any part of the table insert.
8.Repeat Step 6 with the blade in the 45¡ posi- tion.
Figure 15. Setscrews on each corner of insert.
G1023S Series |
