Grizzly G1023S110 instruction manual Belt deflection

!

Figure 36. V-belt deflection.

To adjust V-belt tension:

1.Disconnect the machine from the power source!

2.Loosen the motor mount bolt.

3.Shift the motor up or down to increase or decrease the V-belt tension. Tighten the motor mount bolt.

4.Check the V-belt tension again. Ensure that the motor pulley and arbor pulley are lined up.

To replace the V-belts:

1.Disconnect the machine from the power source!

2.Remove the blade.

3.Adjust the arbor so it is up all the way and in the 90¡ position.

4.Place a board under the motor and loosen the motor mount bolt. Slowly lower the arbor until the motor rests on the board, allowing the belts to be loose on the pulleys.

5.Pull off the old V-belts and replace them with new ones. Have the number from the belt ready when calling the service department for replacements.

6.Raise the arbor and remove the board to adjust the V-belt tension.

7.Tighten the motor mount bolt.

G1023S Series Heavy-Duty 10'' Table Saw -37-