10.Slip the bottom plastic collection bag over the bottom edge of the collector and tighten the clamp on the tightest notch possible.
Note: DO NOT force the clamp, choose the next notch over, then clamp in place.
11.Press the “Y” inlet onto the inlet cover flange, as shown in Figure 13. The inlet is secured to the collector body by a
Figure 13. Installing "Y" inlet.
Test Run
Do NOT put hands or small objects near inlet openings during opera- tion. Objects sucked into the inlet will hit the impel- ler blade. Failure to heed this warning could result in property damage or personal injury.
Once the assembly is complete, test run your machine to make sure it runs properly.
If, during the test run, you cannot easily locate the source of an unusual noise or vibration, stop using the machine immediately, then review the Troubleshooting on Page 29.
If you still cannot remedy a problem, contact our Tech Support at (570)
To test run the machine:
1.Make sure you have read the safety instruc- tions at the beginning of the manual and that the machine is setup properly.
2.Make sure all tools and objects used during setup are cleared away from the machine..
3.Connect the machine to the power source.
4.Turn the machine ON.
5.Listen to and watch for abnormal noises or actions. The machine should run smoothly with little or no vibration or rubbing noises.
6.Turn the machine OFF.
