Design Suggestions
When designing a successful dust collection sys- tem, planning is the most important step. Before you set out to run the first section of duct, consid- er these general guidelines for an efficient sys- tem:
1.Machines that produce the most saw dust should be placed nearest to the dust collec- tor. These machines include thickness plan- ers, shapers, sanders and bandsaws.
2.Ideally, you should design the duct system to have the shortest possible mainline run and to have short secondary branch ducts.
3.Directional changes should be kept to a min- imum. The more directional change fittings you use, the greater the loss of overall pres- sure.
4.Gradual directional changes are more effi- cient than sudden directional changes (i.e. use the largest corner radius possible when changing hose or pipe direction).
5.Each individual machine should have a blast gate to control suction from one machine to another.
6.The simpler the system, the more efficient and less costly it will be.
The best way to plan your new system is to draw a bird’s eye view (as shown in Figure 14) of your shop and sketch the following:
1.Your desired location of the dust collector, usually in a corner or along a wall.
2.The location of each machine in the system.
3.The location of the main line duct and each branch line.
4.The location of any obtrusion such as a joist or heating duct, that will require special duct routing.
4'' | 4'' | 4'' |
Branch Line |
| |
4'' | 5'' | 6'' |
| ||
4'' | Main Line | |
| ||
|
| Dust |
| 4'' | Collector |
|
| 4'' |
Figure 14. Bird’s eye planning view.
G1028Z/G1029 Dust Collector |
