Rotating/Changing
Carbide Cutters
Tools Needed: | Qty |
................. 1 |
The cutterhead is equipped with 96 indexable car- bide cutters. Each cutter can be rotated to reveal any one of its four cutting edges. Therefore, if one cutting edge becomes dull or damaged, simply rotate it 90˚ to reveal a fresh cutting edge (Figure 26).
In addition, each cutter has a reference dot on one corner. As the cutter is rotated, the reference dot location can be used as an indicator of which edges are used and which are new. When the reference dot revolves back around to its starting position, the cutter should be replaced.
Reference Dot |
Figure 26. Cutter rotating sequence.
To rotate or change a carbide cutter:
1.Disconnect the planer from the power source!
2.Remove any sawdust from the head of the carbide cutter Torx screw.
3.Remove the Torx screw and carbide cutter.
4.Clean all dust and dirt off the cutter and the cutterhead pocket from which the cutter was removed, and replace the cutter so a fresh, sharp edge is facing outward.
Note: Proper cleaning is critical to achieving a smooth finish. Dirt or dust trapped between the cutter and cutterhead will slightly raise the cutter, and make noticeable marks on your workpieces the next time you plane.
5.Lubricate the Torx screw threads with a light machine oil, wipe the excess oil off the threads, and torque the Torx screw to
Note: Excess oil may squeeze between the cutter and cutterhead, thereby lifting the cut- ter slightly and affecting workpiece finishes.
Model G1033X (Mfg. since 4/10) |
