Table Adjustments
The bandsaw table will tilt left 15° and right 45°.
To tilt the table:
1.Loosen the locking handle below the table. Figure 12.
Angle Gauge 
Locking Handle 
Figure 12. Table adjustment locations.
2.Tilt the table to the desired angle. Refer to the angle gauge on the table bracket. Double-check proper angle adjustment by placing a machinist’s or combination square against the table and blade and adjust until perpendicular. Figure 13.
3.Re-tighten the locking handle.
If the blade is not centered in the table insert, the table can be shifted side to side for adjustment.
1.Loosen the table locking handle.
2.Shift the table to center the blade in the table insert.
3.Secure the table by re-tightening the locking handle. Check table position to ensure that undesirable shifting did not occur during re- tightening.
If the table will not shift adequately, you will need to reposition the blade.
Figure 13. Squaring the blade to the table.
G1052 9" Bandsaw |
