Grizzly G1067Z instruction manual Installing the Switch

3.Attach the long stand supports to each end assembly using the 5⁄16''-18 x 3⁄4'' carriage bolts provided (Figure 3).

Figure 3.

4.With an assistant, set the lathe bed assem- bly on the stand, orienting the front of the headstock with the switch opening in the stand leg. Bolt the lathe bed to the stand using the eight 5⁄16''-18 x 1 cap screws and hex nuts supplied and tighten down (Figure 4).

Figure 4.

5.At this point tighten down all the bolts on the stand. It is a good idea to do this with the lathe set in place where it will be used.

Installing the Switch

Do not plug cord in until you are ready to test run the lathe. See Test Run section for instructions before initial run.

1.Locate the paddle switch.

2.Press the paddle switch into the cut-out on the face of the leg as shown in Figure 5.

Figure 5.

3.Attach the power wires to the back of the paddle switch as shown in Figure 6. Note— The green ground wire MUST be securely attached to the sheet metal leg.

Figure 6.

G1067Z Wood Lathe -11-