SECTION 4: ASSEMBLY
Beginning Assembly | Dust Ports | |
|
|
|
|
|
|
Most of your new drum sander has been assem- bled at the factory, but some parts must be assembled or installed after delivery. We have organized the assembly process into steps. Please follow along in the order presented in this section.
Keep loose clothing out of the way of machinery and keep hair pulled back.
Disconnect power to the machine when perform- ing any maintenance or assembly. Failure to do this may result in serious personal injury.
Wear safety glasses dur- ing the entire assembly process. Failure to com- ply may result in serious personal injury.
Some metal parts may have sharp edges on them after they are formed. Please examine the edges of all metal parts before handling them. Failure to do so could result in injury.
The Model G1066/G1079 Drum Sander comes equipped with two 4'' dust ports as shown in Figure 2. Apply double sided tape between the plastic dust ports and the sheet metal cover, then secure in place with sheet metal screws.
Figure 2. Top-mounted 4" dust ports.
The Model G1066Z also comes equipped with two 4" dust ports, but these mount in the center of the top and the center of the front on the sheet metal cover. As with the other models, apply dou- ble sided tape between the plastic dust ports and the sheet metal cover, then secure in place with sheet metal screws.
DO NOT operate the Model G1066/G1066Z/G1079 without an adequate dust collection system. This machine creates substantial amounts of wood dust while in operation. Failure to use a dust collection system can result in short and
|
|
|
|
G1066/G1066Z/G1079 Drum Sander | |||
