220V Three-Phase Operation (G1096)
Serious personal injury could occur if you connect the machine to power before com- pleting the setup process. DO NOT connect the machine to the power until instructed later in this manual.
Electrocution or fire could result if machine is not grounded and installed in compliance with electrical codes. Compliance MUST be verified by a qualified electrician!
Full Load Amperage Draw
Amp Draw at 220V | 3.2 Amps |
Power Supply Circuit Requirements
You MUST connect your machine to a grounded circuit that is rated for the amperage given below. Never replace a circuit breaker on an existing cir- cuit with one of higher amperage without consult- ing a qualified electrician to ensure compliance with wiring codes. If you are unsure about the wiring codes in your area or you plan to con- nect your machine to a shared circuit, consult a qualified electrician.
Minimum Circuit Size | 10 Amps |
Power Connection Device
The type of plug and receptacle required to con- nect your machine to power depends on the type of service you currently have or plan to install. We recommend using the configuration shown in Figure 3.
<gdjcYZY |
DjiaZi7dm |
8jggZci |
8Vggn^c\ |
7aVYZh |
<gdjcY^c\E^c |
Figure 3. NEMA 15-15 plug and receptacle.
Extension Cords
Using extension cords may reduce the life of the motor. Instead, place the machine near a power source. If you must use an extension cord:
•Use at least a 16 gauge cord that does not exceed 50 feet in length.
•Ensure that the extension cord contains a ground wire and plug pin.
