Grizzly G1095/G1096 owner manual Base Mounting, Shaper Jointer Tablesaw

Base Mounting

Position the power feeder on the table top to determine where to drill your base mounting holes, so you can maximize power feeder swing and adjustment options.

There are two mounting options available: Through Bolt Mounting and Direct Mounting (discussed on Page 18). Choose an option that suits your requirements.

Whichever way you mount your power feeder, you must be able to use the handwheels and lock levers to position the rubber wheels parallel with the table surface and 1⁄8" lower than the thickness of your workpiece.

Also, you must be able to point the power feeder slightly towards the machine fence (Figure 9). In other words, the tracking of the power feeder must be toed-in approximately 1° to 1.5° degrees toward the machine fence, so the rubber wheels slightly push the workpiece against the fence during cut- ting operations.

Shaper		Jointer	Tablesaw
	;ZcXZ	;ZcXZ	;ZcXZ
			7aVYZ
	8jiiZg
)i]"GdaaZg			;ZZY
BdYZah	;ZZY	;ZZY
		8jiiZg]ZVY

Figure 9. Typical power feed mounting on a shaper, jointer, and tablesaw.

Model G1095/G1096 1-HP Power Feeder -17-