ON/OFF SWITCH
The Model G1131 Radial Drill Press is equipped with a
1.Insert the safety key into the switch mechanism located at the front of the spindle assembly.
2.Flip the key to the ON position.
3.When drilling is complete, switch the key to the OFF position. When the drill press is not in use, remove the key from the switch and store it in a safe place.
4.Loosen the depth stop knob located at the hub of the spindle height wheel and rotate the depth scale counterclockwise until the pointer reaches zero.
5.Tighten the depth stop knob and release the height wheel.
Once the procedure is complete, your drill press will deliver uniformly deep holes until you choose to change your settings.
DEPTH STOP ADJUSTMENT
The Model G1131 Radial Drill Press offers an adjustable depth stop for precision con- trol when making repetitive cuts to an exact depth. To set the depth stop:
1.Adjust your table so your workpiece is close enough to your drill bit to allow travel to the full depth of cut you desire.
2.Drill your first hole to the depth you seek.
3.Turn off the drill press and lower the spindle until the bit reaches the base of your cut. With one hand, maintain that depth.
SPINDLE RETURN SPRING
Although the
Should adjustment be required, carefully loosen the two locknuts on the outside of the spring assembly (located on the spindle housing)
Firmly grasp the spring housing as you loosen the locknuts and gently pull the hous- ing away from the spindle until the notches clear the retainer tab. Turn the housing clockwise – one notch at a time – until the proper tension is attained. Tighten the lock- nuts. Tighten the two nuts together using two wrenches.
