Grizzly G5979 instruction manual Headstock Lock, Spur Center

Headstock Lock

The headstock can be locked into position using the supplied locking handle. To install this handle:

1.Locate the handle, spring and special screw.

2.Slide the spring over the special screw. Push the screw through the locking handle and thread it into the locking clamp located on the side of the headstock.

3.The locking handle is designed so that it can be tightened down and then turned out of the way of the operator. To tighten down the handle, push in and turn clockwise. Releasing the handle will disengage the threaded shaft, allowing you to reposition the lever handle out of the way. To release the lock handle, push it in and turn counterclock- wise.

Figure 7. Attaching the headstock lock handle.

Spur Center

The spur center is a M.T. #2. To install the spur center:

1.Make certain the spur center is clean and free of dirt or grease.

G5979 Wood Lathe

2.Press it into the headstock spindle.

Figure 8. Installing the spur center.

To remove the spur center:

1.Insert the push-out rod into the headstock spindle hole opposite the end of the spur cen- ter.

2.A firm push should release the spur center. You may have to tap on the end of the push rod with a rubber mallet. Be sure to hold the spur center before releasing it so it will not fall on the floor.

Figure 9. Removing the spur center.

-13-