Spur Center |
| Faceplate |
|
|
|
|
|
|
The Model G8690 is supplied with a #1 Morse Taper spur center for use when spindle turning. The spur center is used in conjunction with the tailstock live center. Install the spur center by inserting it into the hole in the headstock spindle end. To remove the spur center from the head- stock, insert a pin into the spindle hole and turn the hex nut counterclockwise with a wrench until the spur center is ejected. See Figure 5A.
We recommend cleaning the spur center taper with mineral spirits. Refer to the safe- ty warnings on the container of the mineral spirits. Failure to clean the mating surfaces may result in separation, and an unsafe condition. Separation is usually a result of oil or grease on the taper.
Motor Housing |
Spur Center |
M.T #1 |
Hex Nut |
Figure 5A. Hex nut installed before inserting
spur center.
The faceplate is used for turning plates and bowls. To install the faceplate, remove the spur center. Insert a pin in the spindle shaft to hold the spindle, and thread the faceplate onto the spindle threads as seen in Figure 6. Tighten securely with your fingers, and use the mounting holes on the faceplate to attach wood stock with wood screws.
Figure 6. Installing the faceplate.
|
|
|
|
|
|
|
|
|
|
|
|
G8690 Variable Speed Wood Lathe | |||
