2.Loosen the large hex bolt and the jamnut in the center of the table trunnion.
3.Raise the upper blade guide assembly and place a 6" machinist’s square on the table against the blade as shown in Figure 16. Notice how far out of square your table is and approximate this distance by adjusting the positive stop up or down. Turning the positive stop counterclockwise will raise it and clockwise will lower it. Adjust the posi- tive stop so the table will stop at a 90° angle (square) to the blade.
4.Lock the positive stop by tightening the jam- nut. Do not let the stop turn while tightening the jamnut. Tighten the large hex nut in the center of the table trunnion.
5.Set the angle pointer to zero on the table tilt gauge.
Figure 16. Squaring table to blade.
Table Tilt
To tilt the table:
1.Disconnect power to the bandsaw!
2.Loosen the large hex bolt in the center of the table trunnion.
3.Tilt the table to the desired angle. Refer to the angle gauge.
4.Tighten the large hex bolt in the center of the table trunnion.
|
|
|
|
|
|
|
|
|
|
|
|
24" & 27" Resaw Bandsaws | |||
