Blade Guard | Table Stop | |
|
|
|
|
|
|
The blade guard is attached to the guide post above the upper blade guide assembly. For prop- er setup, the blade should be centered in the blade guard.
To center the blade guard:
1.Loosen the hex bolt that secures the blade guard bracket to the guide post.
2.Rotate the blade guard bracket in the appro- priate direction until the blade guard is cen- tered around the blade as illustrated in
Figure 14.
3.Tighten the hex bolt that secures the blade guard bracket to the guide post.
Blade
Blade
Guard
Figure 14. Blade centered in blade guard.
The positive stop under the table (see Figure 15) allows you to repeatedly square up the table after adjusting the table tilt. To adjust the positive stop so the table will return perpendicular (90°) to the blade after angle cutting:
1.Make sure the bandsaw is unplugged!
Figure 15. Positive stop.
Always disconnect power to the machine when making adjust- ments. Failure to do this may result in serious personal injury.
|
|
|
|
|
|
|
|
|
| 24" & 27" Resaw Bandsaws | |
|
|
