
2.6 | 2 Troubleshooting |
If you cannot format the HDD using the test program, go to Procedure 4.
Procedure 4 Test Program Check
Run the HDD test program stored on the maintenance test program disk for all test items. See Chapter 3 for details on how to use the test program.
If an error is detected during the HDD test, an error code and status will be displayed. The error codes and their status names are listed in Table
| Table |
|
|
Code | Status |
1 | Get Parameter Fail ! |
2 | Read Old Data Error |
3 | Write Pattern Error |
4 | Read Back Data Error |
5 | Data Compare Error |
6 | Restore Data Error |
7 | Read Verify Error |
9 | Seek Error |
10 | Disk Controller Self Test Failed |
11 | Disk Controller Test unexpected interrupt Failed |
12 | Disk Controller action Test Failed |
13 | disk dos not support SMART |
14 | disk read attribute threshold error |
15 | disk read attribute value error |
16 | disk SMART attribute value error |
TECRA S1 Maintenance Manual |