
4 Replacement Procedures | 4.15 Display Mask |
Installing the Display Mask
Install the display mask according to the following procedures and Figure
1.Place the display mask in the correct position and fasten the following 18 latches, in that order:
-Four top latches
-Four latches on each of the left and right sides
-Six bottom latches
2.Place the display module in the correct position and fasten the following 8 screws, in that order:
-Two M2.5x3.5 black
-Two M2x5.5 black
-Two M2.5x3.5 black
3.Place the display mask in the correct position and fasten the following 2 bumps and seals, in that order:
-Two rubber bumps on the top
-Two silver seals on each of the left and right sides
-Two black seals on the bottom
TECRA S1 Maintenance Manual |