Toshiba TECRA S1 - page 86

3 Diagnostic Programs 3.2 Quick Start
12 TECRA S1Maintenance Manual
 Program Name and Its Version: Service Diagnostic Ver1.00;
 Test Module Name: Label the name and version of the test module. For example, in the
above screen, the name of the test module is ‘Memory Tester Build Date 2002.12.31’.
 Status Bar: Located at the bottom of the screen as follows:
The status bar is used to indicate the current script setting and test status. It consists of two
lines that includes the information as follows:
 Test Mode: TIMEBOUND or LOOPBOUND, e.g. LOOPBOUND in the above screen;
 Script File Name: Script file name, e.g. ‘Quick.INI’ in the above screen;
 Current Time(C. TIME): Current system time, e.g. ‘C.TIME:2002-12-22 10:46:05’ in
the above screen;
 Test Time Remaining (LEFT): In TIMEBOUND mode, it would display the remaining
test time at the same location as Current TIME (C. TIME) in the above screen;
 Current Loop Count: In LOOPBOUND mode, it will display the total LOOP number
planning to execute and the current LOOP number have been finished, e.g. ‘COUNT:
01/01’ in the above screen;
 CPU Temperature: Detect the temperature in the current CPU, e.g. ‘CPU: 49C’ in the
above screen;
�� Remaining Battery Capacity: Remaining Battery Capacity detected in the current
Battery, e.g. ‘BAT: 97%’;
 Test Order: Define the test sequence. There are two sequence modes: Sequential Test
Mode and Random Test Mode. The default mode is Sequential Test Mode, it would
displays ‘ORDER: SEQ’ as in the above screen;
 LOG File Name: Display the file name of the test log, e.g. Quick.Log in the above
screen;
 Start Test Time (S.TIME): Display the test start time for the current test item or the test
script, e.g. ‘S.TIME: 2002-12-22 10:46:05’ in the above screen;
 Break On Error: Display ‘HALT’ as shown in the above screen when ‘Break On Error’
is enabled;
 Wait On Error: Display ‘WAIT’ as shown in the above screen when ‘Wait On Error’ is
enabled;