setup | tests | equipment |
| |
system devices |
|
|
| |
|
|
| Low Heating Airflow |
|
Equipment Name |
|
|
|
|
Heating Airflow Control Type | current value: |
| ||
|
| |||
Low Heating Airflow |
|
| 400 |
|
High Heating Airflow |
|
|
|
|
High Cooling Airflow |
|
|
| edit |
|
|
|
| |
Airflow Profile − Cooling | tests | equipment |
| |
setup |
| resetAll | ||
High HP Airflow |
|
|
| |
|
|
|
| |
system devices |
|
| ||
Continuous Indoor Blower Airflow | Low Heating Airflow | |||
|
|
| ||
HeatingEquipmentIndoor BlowerNameOFF Delay | back |
| ||
|
|
|
| |
Heating Airflow Control Type | current value: |
| ||
Low Heating Airflow |
| 325 |
| |
|
|
|
| |
When finished, press back; equipment parameters screen (figure 21B re- turns); then press next.
ther run tests as before or press skip tests.
The esting process screen" (see figure 20) again appears; use the EXIT button (if you have completed the required setup), or use diagnostics but- ton (to analyze the system; see Page 21), or use equipment button again (if you want to make any further changes to device details).
Table 3 on (on Page 37) shows a list of Editable Parameters for the currently available devices designed to communicate in this system. Other devices and additional parameters may be added at a later time. Check the unit installation manuals (i.e. furnace, air handler, heat pump, ac unit) for current information and default parameters.
Run Diagnostics
High Heating Airflow
High Cooling AirflowLow Heating Airflow
Range is 325 to 450
Airflow Profile − Cooling
Default is 400, inc: 25
High HP Airflow
set−to
Continuous Indoor Blower Airflow
Heating Indoor Blower OFF325Delay
save cancel
9:39 am Aug 15, 2012
edit
resetAll
back
NOTE − To run diagnostics and insure the system works properly, the system should be running
cooling, heating, dehumidification, humidification, or continuous fan opera- tion.
If you need to run diagnostics to analyze the system, press the diagnostics
button. The | A) will open. |
Use the arrow buttons to scroll through the list of items found on the left of the screen. The right side of the screen shows which item is selected. Use start to begin the process. A
being conducted, followed by a screen similar to figure 23B.
Figure 22. Edit equipment details
Use the arrow buttons to scroll through the information and take note of any found to be out of operating range.
Page 21 | icomfort |
