Add (or Remove) Humidifier (skip if no humidifier is being used)
Before adding a humidifier, be sure that:
Sthe humidifier is wired to the furnace or air handler control as shown on the Optional Accessories wiring diagram (see Page 61),
Sthe entire system is wired, powered up, and the thermostat has detected the system’s installed communicating devices, and you are at the or Remove Non−communi- cating equipment?" screen (see figure 7, Page 8).
system devices |
| Add or Remove Non− |
|
|
|
|
| yes | |
System |
| communicating | 1 | |
Heat Pump |
| equipment? |
|
|
|
|
|
| |
Furnace |
| to add/remove/adjust a device, | ||
non−communicating device list | ||||
Thermostat |
| select it, then press edit |
| |
Humidifier |
|
| ||
|
|
|
| |
Dehumidifier |
| current value: |
|
|
|
|
|
| |
Electronic Air Cleaner |
| 2a Not Installed |
|
|
Select one | Humidifier | 2b | edit | |
|
| |||
| 3a |
| next | |
Not Installed | Bypass (24VAC) Humidifier |
|
| |
Power (120VAC) Humidifier | Bypass and Power Humidifier |
|
| |
(available with furnace equipped systems only) |
|
| ||
NOTE − Adding humidity regulating non−communicating devices may be a 2−step procedure: 1st, the device must be installed (this page; after the humidifier is installed, the operation mode defaults to
2nd, (if you want another mode, i.e. Precision, Basic Dew Point, or Precision Dew Point, the device requires further configuration (see Page 15).
To add (or remove) a humidifier,:
1. Press the yes button on this screen (see 1).
2. In the2a) to highlight Humidifier (note the current value, Not Installed) and press edit (2b).
3.Touch one of the radio buttons (3a) to select the type of humidifier (or select Not Installed, if removing humidifier); press save (3b).
4.The previous screen returns, but the current value now shows your selection (4a). Press the back (4b) button.
5.The
devices list (5a). At this point, you may add more equipment (press yes) or if finished, press the next (5b) button to advance to the
(see page 15).
6. (If you want other than the default | ) Configure the |
humidifier as described on Page 15. |
|
3b save | cancel |
system devices
System
Heat Pump
Add or Remove Non−
communicatingyes equipment?
non−communicating device list
Humidifier
Dehumidifier
Electronic Air Cleaner
to add/remove/adjust a device,
select it, then press edit
current value:
Bypass (24VAC) Humidifier
4a
edit
Furnace
Thermostat
Bypass (24VAC) Humidifier
5a
5b
back next
back 4b
9:39 am Aug 15, 2012
Figure 9. Add or remove non−communicating device
Page 11 | icomfort |
