Add or Remove Non−communicating equipment
Figure 7 (previous page) shows how to access the communicating equipment" screen.
Adding Non−Communicating Outdoor unit See figure 8 for details for adding/removing an outdoor unit.
Adding Humidifier The procedures in figure 9 describe adding a non− communicating humidifier which will be controlled by the icomfort
Adding Dehumidifier procedures in figure 10 describe adding a non−communicating dehumidifier controlled by the icomfort
NOTICE
For details about how the humidification and dehumidification modes operate and how to configure those modes, see additional in- formation beginning on Page 18.
HUMIDITY CONTROL TIPS
SThe standard humidification mode is
during a call for heat, if there is a humidification demand).
SSensed outdoor temperature, required for some features, is provided from one of the following sources:
A downloaded via Wi−Fi when available (primary source), B sensor furnished with icomfortt−enabled outdoor units,
C separate outdoor sensor connected to the furnace or air handler sensor" connections.
NOTE − If no source for outdoor temperature is present, Precision Dew Point Control" modes are not available.
SIf you do not have the ability to select or adjust the Humidity RH set-
point on thebutton, the control is set for
Only." In the installer program, go the equipment button and select
and press the | edit button. Select |
Mode" and press edit. Choose | |
Control" or | save. |
Adding non−communicating accessories maintenance timer reminders to accessories is a simple process of
which effectively tells the thermostat to activate access to its service timers.
Timers are available for two (2) filters, Humidifier pad, UV bulb maintenance and the PureAirt Air Purification system.
Page 9 | icomfort |
