Table 3. Adjustable Parameters Table (Installer)
Parameter Name | Default | Min. | Max. | Incr. | Dependency | Note | Installer entry |
|
|
|
|
|
|
|
|
Other Parameters
Equipment Name | Furnace | N/A | N/A | N/A | None | Up to 35 characters |
|
|
|
|
|
|
|
|
|
Continuous Indoor Blower Airflow | DIP SW (See | Min | Max | 25 | None | 1/2 HP blower |
|
| Note 3 at | CFM | CFM |
|
|
|
|
| end of table) |
|
|
|
|
|
|
| Min | Max | 25 |
| 1 HP blower |
| |
|
|
|
| ||||
|
| CFM | CFM |
|
|
|
|
|
|
|
|
|
|
|
|
Humidification Airflow | Same as | Min | Max | 25 | Humidifier present | 1/2 HP blower |
|
| above | CFM | CFM |
|
|
|
|
|
|
|
|
|
|
|
|
|
| Min | Max | 25 |
| 1 HP blower |
|
|
| CFM | CFM |
|
|
|
|
|
|
|
|
|
|
|
|
Dehumidification Airflow Percentage
140
(=70%)
120 | 160 | 2 | OU present and SC | Percent of High Cooling |
(=60%) | (=80%) | (=1%) | (Subnet Controller) | Airflow |
|
|
| algorithm support |
|
|
|
|
|
|
Note 1: Minimum Outdoor Unit Cooling Stage as a percentage of High Cooling Airflow (value is rounded up to the closest number on 25 CFM resolution.
Note 2: Minimum Outdoor Unit Heating Stage as a percentage of High Heat Pump Airflow (value is rounded up to the closest number on 25 CFM resolution).
Note 3: All communicating Installer Parameters default CFM values based on DIP switch setting (non−communicating value) are calculated using the CFM conversion tables and rounded up to closest number on 25 CFM resolution.
Note 4: Parameter dependency − Certain parameters are dependent on others and may not be shown on the display.
Note 5: Default Values − Jumper/DIP switches impact the default value of some parameters.
506920−01 09/12 | Page 42 |
