Lennox International Inc XP1906, XP2101, XC2105, XC1702 Adjust a non−communicating device setting

Adjust a setting... Configure Humidifier (skip if no humidifier is being used or if humidifier is being used and default

						Pre−adjustment REQUIREMENTS:
System Devices		To adjust a setting, highlight it,					1st, the device has been installed (see Page 11).
							2nd, you pressed next at the 11).
		then press Edit
System						Configure the device as follows:
Air Conditioner			System			1.	In the		1a) to highlight System. Press edit (1b).
Furnace					about	2.	In the		2a) to highlight Humidification Control Mode.
Thermostat		1a					The current value defaults to Basic mode. Press edit (2b).
Power (120VAC) Humidifier				1b	edit	3. Touch one of the radio buttons (3a) to select the mode of humidification control;
							press save (3b). (After saving, check that the current value now shows the new
							selection).
System			Humidification Control ModeresetAll			4. Use arrows (4a) to highlight any red colored text in the list (e.g. select Max Humidifi-
2nd Stage Differential							cation Setpoint). Press edit (4b).
						5. Use arrows (5a) to make changes; press save (5b). Repeat for other red settings.
Staged Delay Timers			current value:
							You will not be able to advance to the next step until all red settings have been
				back	next
2nd Stage Delay			Basic				removed..
		2a
Dehumidification Control Mode						6.	Press the back button to return to
				2b
Humidification Control Mode					edit	NOTE − If the defaults for the settings shown in red, you are not required to make any changes,
						but you must go into the edit tool, and press save (5b). When all red text is gone, the back button
Humidification Control Mode						will appear; press it to return to the
					reset
Select one
Display Only		Basic		System			Max Humidification Setpoint
	3a			1st Stage Differential
Precision		Basic Dew Point Control back					current value:
Precision Dew Point				2nd Stage Differential					Max Humidification Setpoint
							45
				Staged Delay Timers						Range is 15 to 45
				2nd Stage Delay				4b	Default is 45, inc:1
				Dehumidification Control Mode		4a			edit	set−to
				Humidification Control Mode			please view and save all			45	5a
							red settings
save 3b		cancel		Max Humidification Setpoint
									reset
				OK/Humid Boundary
									5b	save	cancel
				Outdoor Temperature Reading
							back		(returns to
									adjust a
									setting
				9:39 am Aug 15, 2012					screen)

Figure 14. Adjust a non−communicating device setting

Page 15 icomfort Wi-Fit 7−Day Programmable Communicating Thermostat