Lennox International Inc XC1702, XP2101, XC2105 Accessing device to modify, Modify device settings

Use the up/down arrows to scroll through the device’s settings. The current setting will be displayed on the right−hand side of the screen (figure 12). For example, current value: disabled. Press edit if you want to modify that setting, or press back to return to the previous screen.

Available settings for the devices depend on the installed components. Shown below is an example of enabling and changing the balance point control from default (Disabled) to Enabled. After selecting Enabled, press save to save the changes and return to the previous screen.

The returning screen may appear with the message in red 3, note that two additional items are listed in red. Use the arrows to scroll and highlight each item appearing in red. Press edit, make any desired changes, and press save.

When all affected settings have been edited/saved, the red message disappears. Press back to return to the o adjust a setting ..." screen.

If no more adjustments are necessary, press next to advance to the

run" screen (see Page 19).

System		Balance Point Control
Staged Delay Timers
2nd Stage Delay		current value
3rd Stage Delay		Disabled
Balance Point Control
Humiditrol Comfort Adjust		edit
Balance Point Control
Select oneControl Mode
Min Dehumidification Setpoint		reset
OK/HumidDisabledBoundary	Enabled
		back
save	cancel

System

Staged Delay Timers 2nd Stage Delay 3rd Stage Delay

Lock In 2nd stage HP by Outdoor Temp Balance Point Control

High Balance Point

Low Balance Point

Humiditrol Comfort Adjust

Humidification Control Mode

Min Dehumidification Setpoint

Balance Point Control
current value
Enabled
please view and save all	edit
red settings

High Balance Point reset

Range is −17 to 75

Default is 0, inc:1

back

set−to

50

save cancel

Figure 12. Accessing device to modify Figure 13. Modify device settings

G71MPP or SLP98 Furnace Note:

If your icomfort Wi-Fit thermostat is being used with a G71MPP or SLP98 furnace and is set to variable−capacity mode of operation (the icomfortt default with these units), the thermostat’s settings for stage timers are ignored (even if shown enabled in the thermostat). The stage timer will be used on the cooling side. The furnace software sets and controls the firing rates. The only other controlling factor is the stage temperature differentials. In Load−Tracking Variable Capacity (default for these furnaces), both stage timers and temperature differentials are ignored.

506920−01 09/12 Page 14