Reconfigure a system
If any component of the HVAC system has been changed, e.g. replacing an outdoor sensor, reconfiguring the system will be required. To begin reconfi- guring a system (after you have accessed the program from the Lennox logo [previous page]), press the setup button (1, figure 34A). The tart system configuration" screen (fig. 34B) will appear. Press start (2, figure 34B) to pro-
ceed. The 34C) will appear. This re- minder notes that system configuration may affect some existing device set- tings and prompts to confirm or cancel the configuration process.
Press confirm (3, figure 34C) to continue system configuration; the screen will change to the system discovery screen. At this point, the program goes through the same setup as the initial setup process which begins on Page 4.
NOTE − below) appears only
when a device has been removed and replaced with a compatible device.
Missing | Found Compatible |
Device Equipment Type No. | Device Equipment Type No. |
Model No. (control model no.) | Model No. (control model no.) |
Serial No. (control serial no.) | Serial No. (control serial no.) |
Settings were not copied
setuptests
1
Select Devices
System
Furnace
Thermostat
9:39 am Aug 15, 2012
equipment alerts diagnostics
system and device alerts
setup | tests | equipment | alerts | diagnostics |
setup | tests | equipment | alerts | diagnostics |
press start button only if you wish to setup a new system,
select all or to re−setup an existing system
configuring the system may effect some devices.
deselect all | view active | 2 | confirm to continue or press cancel | |
|
|
| ||
|
| start | 3 |
|
| view cleared |
|
| |
|
|
| back |
|
|
|
| confirm | cancel |
| EXIT |
|
|
|
EXIT
9:39 am Aug 15, 2012
EXIT
9:39 am Aug 15, 2012
Figure 34. Re−configuration process
Page 29 | icomfort |
