Makita 6832 instruction manual Adjusting knob l L z e s s

Setting the slide plate (Fig. 5 & 6)

When driving screws 25 mm ( I " ) - 41 mm (1-5/8")long, set the slide plate to the posi- tion shown in Fig. 5. To set the slide plate, press it in the direction of the arrow while depressing the screw in the center of the adjusting knob.

Z5mmll	1 -
41 mm l l	518 \
-	4	Slide plate

\ Press

Adjusting knob l L z e s s
Screw	Slide plate

I

Fig.

When driving screws 40 mm (1-9/16") - 57 mm (2-1/4") long, set the slide plate to the position shown in Fig. 6. To set the slide plate, just press it in the direction of the arrow.

Adjusting the driving depth (Fig. 7 ) Depress the stopper plate as far as it will go. While keeping it in this position, turn the adjusting knob until the bit tip projects a p p r o x . 5 mm (3/16")from the stopper plate. Drive a trial screw. If the screw head projects above the surface of the workpiece, turn the adjusting knob in the + (plus) direction; if the screw head is countersunk, turn the adjusting knob in the - (minus) direction.

Slide plate

~ ~ ~ j , , G , , ,

Stopper plate

Casing

Adjusting knob

7