Grizzly G1199, G1200 instruction manual Table Adjustments, Spindle Adjustments

Spindle Adjustments Table Adjustments

To stop the vertical travel of the drill bit at a desired depth, loosen the scale set knob located on the feed shaft assembly, rotate the handles to the desired depth and tighten the scale set knob.

Figure 12.

To hold a stationary depth, loosen the scale set knob and rotate the feed shaft to its lowest point. Then, rotate spindle depth to the desired depth and tighten the scale set knob. This will lock the spindle at the desired depth.

scale set knob

Figure 12.

1.To adjust the table up or down, loosen the col- umn lock handle and turn the crank handle to the desired height. Re-tighten the column lock handle. Figure 13.

lock handle

Figure 13.

2.To swing the table, loosen the column lock handle and swing the table to the desired position. Re-tighten the column lock handle. For long workpieces, swing the work table away 180° and use the base as your table.

Figure 13.

3.To rotate the table, loosen the table lock han- dle, rotate the table to the desired position and re-tighten the table lock handle. Figure 14.

-12- G1199/G1200 Drill Press