Grizzly G1200, G1199 instruction manual Beginning Assembly, Base/Column

SECTION 2: ASSEMBLY

Beginning Assembly Base/Column

Most of the Drill Press has been pre-assembled at the factory. The few remaining pieces should go together quickly and easily. Assembly is straight forward and with just a few tools you can do the entire job quickly and easily. This manual is written for the G1199/G1200 model. The only difference between the two regarding assembly is the length of the column.

CAUTION: All die-cut metal parts have a sharp edge (called “flashing”) on them after they are formed. This is removed at the factory. Sometimes though, a bit of flashing might escape inspection. Please examine the edges of all die- cut metal parts before handling them.

Tools Required: Only a few common tools are needed to assemble this machine. Specifically, a 14mm open end wrench, Phillips screwdriver and 3mm and 4mm Allen wrench.

1.Place the base on the floor (if G1200) or on a suitable bench (if G1199). In either case, be sure the surface is flat and stable.

2.Place the column onto the base, line up the four holes and secure tightly with the four M10-1.5 x 40mm Hex Head Bolts provided.

Figure 2.

Figure 2. Base to column.

G1199/G1200 Drill Press -7-