SECTION 3: ADJUSTMENTS
Speed Change
Remember to disconnect the drill press from the power source before attempting any adjustments.
1.To change speed, loosen the two lock knobs, one on either side of the head. Figure 10.
2.Turn the cam lever so the motor pulley moves toward the center pulley. Figure 10.
3.Select the proper speed by referring to the chart inside the pulley cover. Move the belts into the corresponding position for the select- ed speed. Figure 11.
4.Rotate the cam lever so the motor pulley moves away from the center pulley and tight- ens the belt.
5.While holding tension on the cam lever, tight- en the locking screws on both sides of the head.
6.Close the cover. CAUTION: Never run the drill press with the cover open.
NOTE: The speed chart under the pulley cover reflects two different power cycles for the motor. Use the 60 cycles per second spindle R.P.M. ref- erence in the U.S.A.
Figure 10.
Figure 11.
|
|
|
|
|
|
|
|
|
|
|
|
G1199/G1200 Drill Press | |||
