Toshiba TECRA S1 - page 197

4.12 Top Cover with the Display Assembly 4 Replacement Procedures
TECRA S1 Maintenance Manual 4-49
Installing the Top cover with the Display Assembly
Install the top cover with the display assembly according to the following procedures and
Figures 4-29,4-30,4-31 and 4-32.
1. Place the top cover, adjusting its position. Then attach the latches.
2. Fix top cover with two M2.5x3.5 black flat-head screws.
CAUTION: Use care to avoid that the MIC cable for MIC is caught between the top
cover and base body.
3. Connect the MIC cables to CN13 on the system board.
4. Connect the speaker extended cable to CN5005 on the system board.
5. Secure top cover with two black flat-head screws.
6. Turn the computer upside down and fix it with the following 12 screws:
- Seven M2.5x6 black bind screws
- Five M2.5x3.5 black flat-head screws
7. Restore the normal computer placement.
8. Place the display panel in their correct position and push the wireless antenna cable
into the guides on the top cover.
9. Connect the LCD/FL cable to CN3 on the system board.
10. Close the display panel and turn the computer upside down and fix it with two
M2.5x6 black bind screws.