3 Diagnostic Programs

3.6 Memory Test

 

 

 

Extended Memory Start Address and Extended Memory End Address (MB): Set the range of extended memory that is to be tested. The test coverage will base on the value setting in ‘Percent (%)’ mentioned at below.

Percent (%): Choose the percentage of the defined range of the memory to be tested.

1. Write/Read Cycle Test

Test by using both read and write instructions.

2. Read Cycle Test

Test by using read instructions.

Subtest 04 Walking 1’s Test

The test item is to make sure that there is no short circuitry issue in memory chip. The parameter dialog window is the same as that in ‘Subtest 02 Pattern’.

Subtest 05 Walking 0’s Test

The test item is to make sure that there is no open circuitry issue in memory chip. The parameter dialog window is the same as that in ‘Subtest 02 Pattern’.

Subtest 06 Memory Address

This test item is to check short and open issue on memory address lines.

Subtest 07 Refresh Test

This test item is to check whether the memory refresh works normally. The parameter dialog window is as follows:

Subtest 08 Cache Memory

34

TECRA S1Maintenance Manual

Page 108
Image 108
Toshiba TECRA S1 manual Subtest 04 Walking 1’s Test, Subtest 05 Walking 0’s Test, Subtest 06 Memory Address