Main Table Angle
The main table position can be adjusted from 0° - 45°. To adjust the angle position of the main table:
1.Loosen the lock handles underneath each end of the main table as shown in Figure 14.
2.Tilt the table into the desired position. The scale on the side of the bracket can help you find specific angles. While holding the table in the desired position, tighten each of the lock- ing handles loosened in Step 1.
3.Changing the table angle may reduce the clearance between the inside edge of the table and the sanding belt surface. If there is less than 1⁄16" clearance, loosen the fixing bolts located on the underside of the table mounting bracket as shown in Figure 14. Pull the table and mounting bracket away from the sanding belt so there is at least 1⁄16" clearance between the inside edge of the table and the sanding belt surface.
4.While holding the main table in the desired position, tighten the fixing bolts loosened in Step 3.
5.Recheck the clearance between the main table and the sanding belt. Repeat Steps 3 and 4 if necessary.
Adjust this pointer to set scale accuracy.
1 of 2
Lock
Handles
1 of 2 Fixing 
Bolts
Figure 14. Main table angle adjustment lever.
6.We recommend using a square to adjust and/or verify the main table angle scale accu- racy as shown in Figure 15.
G9984/G9985 Oscillating Belt Edge Sander
Figure 15. Setting main table to 90°.
Miter Gauge
The main table has a stationary miter gauge that is used to hold the workpiece at various angles against the sanding belt. To adjust the miter gauge:
1.Loosen the lock handle shown in Figure 16.
2.Rotate the miter gauge to the desired angle.
3.While holding the miter gauge in the desired position, tighten the lock handle loosened in Step 1.
4.We recommend using a square to adjust and/or verify the miter gauge scale as shown in Figure 17.
Lock Handle
Adjust this pointer to set scale accuracy.
Figure 16. Main table miter gauge.
