Grizzly G9984, G9985 instruction manual Maintenance, General, Tables, Lubrication

SECTION 7: MAINTENANCE

!	Disconnect power to the
	machine when perform-
	ing	any	maintenance,
	assembly		or	adjust-
	ments. Failure to do this
	may	result in		serious
	personal injury.

Keep loose clothing rolled up and out of the way of machinery and keep hair pulled back.

Wear safety glasses during the entire mainte- nance process. Failure to comply may result in serious personal injury.

General

Regular periodic maintenance of your Model G9984/G9985 will ensure its optimum perfor- mance. Make a habit of inspecting your machine each time you use it. Check for the following con- ditions and repair or replace when necessary:

1.Loose mounting bolts.

2.Worn switch.

3.Worn or damaged cords and plugs.

4.Damaged or worn sanding belt.

5.Any other condition that could hamper the safe operation of this machine.

Tables

Tables can be kept rust-free with regular applica- tions of products like Boeshield® T-9. For long term storage you may want to consider products like Kleen Bore's Rust Guardit™.

Lubrication

There are (2) grease fittings shown in Figure 20. Grease these points after approximately 50 hours of use.

All other bearings are sealed and permanently lubricated, simply leave them alone until they need to be replaced. Do not lubricate them.

Grease Fittings

Figure 20. Oscillation grease fittings.

-20- G9984/G9985 Oscillating Belt Edge Sander