Grizzly G9986 instruction manual Clean Up Assembly, To assemble the drill press

Clean Up Assembly

The unpainted surfaces are coated with a waxy oil to protect them from corrosion during ship- ment. Remove this protective coating with a sol- vent cleaner or citrus-based degreaser such as Grizzly’s G7895 Degreaser. To clean thoroughly, some parts may need to be removed. For opti- mum performance from your machine, make sure you clean all moving parts or sliding contact surfaces that are coated. Avoid chlo- rine-based solvents, such as acetone or brake parts cleaner, as they may damage painted sur- faces should they come in contact. Always follow the manufacturer’s instructions when using any type of cleaning product.

Gasoline and petroleum products have low flash points and could cause an explosion or fire if used to clean machinery. DO NOT use gasoline or petroleum products to clean the machinery.

Many of the solvents commonly used to clean machinery can be toxic when inhaled or ingest- ed. Lack of ventilation while using these sol- vents could cause seri- ous personal health risks or fire. Take precautions from this hazard by only using cleaning solvents in a well ventilated area.

-10-

The drill press cannot be safely operated unless it is properly assembled.

To assemble the drill press:

1.Mount the column to the base with the three included hex bolts and flat washers (Figure 5).

Figure 5. Column secured to base.

2.Slide the table assembly over the column and lock into place with the swivel handle (Figure 6).

Figure 6. Table assembly installed on column.

Model G9986 8" Drill Press