Oiling The Nailer/Stapler
Special oil has been included with your new Grizzly nailer/stapler to help maintain its useful life. Place one drop of oil in the nailer/stapler air inlet (as shown in Figure 5) before every use. Wipe off any excess oil near the nailer/stapler exhaust to avoid dust
Another option to manual oiling would be to install a lubricator in your air compressor line. If your air compressor line already has a lubricator, then regular lubrication of your nailer/stapler will not be necessary. Just make sure there is always oil in the lubri- cator.
As mentioned before, the best option is to install a filter/lubricator/regulator unit such as the Grizzly Model H2333 in your air line.
Figure 5. Lubricating the nailer/stapler via
air inlet.
H2912/H2913
Cleaning The Nailer/Stapler
Use a good solvent to clean the nose assembly of the nailer/stapler. Always be sure that the nailer/stapler is dry before using it again.
Do not allow dust, chips, sand, etc. into the air connectors or into the body of the nail- er/stapler; this may result in leaks and damage to the nailer/stapler and the air couplings.
Never use gasoline or other flamma- ble liquids to clean this tool. Vapors in the tool may ignite, causing the tool to explode. Ignoring this warning may lead to serious personal injury or even death!
Always disconnect air from the nail- er/stapler whenever servicing! During maintenance, a nailer/stapler connected to air may fire accidental- ly, causing serious personal injury!
