Grizzly H3140 owner manual Test Run, To test run the machine Perform Sanding Belt Tracking on

Test Run

Once the assembly is complete, test run your machine to make sure it runs properly.

If, during the test run, you cannot easily locate the source of an unusual noise or vibration, stop using the machine immediately, then review the Troubleshooting on Page 22.

If you still cannot remedy a problem, contact our Tech Support at (570) 546-9663 for assistance.

To test run the machine:

1. Perform Sanding Belt Tracking on Page 17.

Model H3140 (Mfg. after 6/02)

2.Make sure you have read the safety instruc- tions at the beginning of the manual and that the machine is set up properly.

3.Make sure all tools and objects used during setup are cleared away from the machine.

4.Turn the machine ON.

5.Listen and watch for abnormal noises or actions. The machine should run smoothly with little or no vibration or rubbing noises.

—Strange or unusual noises should be inves- tigated and corrected before operating the machine further. Always disconnect the machine from power when investigating or correcting potential problems.

6.Turn the machine OFF.

-13-