Grizzly H3140 owner manual Sanding Belt Replacement, To change the sanding belt

Sanding Belt

Replacement

Some sanding belts are designed to sand in only one direction and will have directional arrows on the back of the belt. The Model H3140 is designed so that the sanding belt travels downward at the sanding table.

To change the sanding belt:

1.DISCONNECT SANDER FROM POWER!

2.Unscrew the knob from the sanding belt cover (Figure 13) and remove the cover from the sander.

Knob
	Sanding Belt
	Cover

Figure 13. Sanding belt cover.

-18-

3.Press firmly against the tracking adjustment knob to remove the tension from the sanding belt.

4.Roll the old sanding belt off the three pulleys, and roll the new belt back on, making sure the directional arrows on the back of the belt point downward at the table (Figure 14).

Sanding

Belt

Direction

Figure 14. Replacing sanding belt.

5.Make sure the sanding belt is positioned in the center of all three pulleys.

6.Replace and secure the sanding belt cover.

7.Check and the adjust the sanding belt track- ing, as instructed on Page 17.

Model H3140 (Mfg. after 6/02)