Jig Setup for a Left- Tilt Table Saw
In this procedure you will partially dissemble the tenoning jig and reassemble it for use on a
To set up the jig for a left tilt table saw:
1.Insert the jig guide bar into the miter slot in the
2.Loosen the small lock lever and remove the large lock lever (see Figure 5).
Small
Lock
Lever
Set Screw
Large
Lock
Lever
Figure 5. Assembled jig.
3.Loosen the pointer screw, and turn the point- er 90º so the jig assembly and base can be separated (see Figure 6).
Micro
Adjustment
Assembly
Pointer 
Figure 6. Jig base on a right-tilt table saw.
4.Use the 3mm hex wrench to loosen the set- screw shown in Figure 5.
5.Slide the micro adjustment assembly out of the jig, and lift the jig assembly from the base as shown in Figure 6.
6.Use the 4mm hex wrench to loosen and remove the two button head screws (Figure 7) that hold the guide bar to the base.
Right-Tilt
Saw Location
Button
Head
Screw
Left-Tilt
Saw
Location
